Carbide Wear Plates for Chutes and Hoppers

Introduction

Chutes, hoppers, and bins handle abrasive bulk materials that quickly wear through steel. Tungsten carbide wear plates provide long-lasting protection.

Where Wear Occurs

Wear is concentrated at impact points, sliding surfaces, and high-flow areas. Carbide plates are installed in these critical zones to protect the steel structure.

Installation Options

Carbide plates can be bolted, bonded, or brazed onto steel surfaces. Bolted plates allow replacement when worn. Brazed plates provide a permanent solution.

Material Benefits

Carbide plates last 10 to 50 times longer than steel in abrasive service. They reduce maintenance downtime and prevent costly structure replacements.

Custom Configurations

Plates can be custom shaped and sized to fit specific equipment. Mosaic tile patterns are used for large surfaces, optimizing cost and coverage.

Conclusion

Carbide wear plates are a cost-effective solution for protecting chutes and hoppers from abrasive wear. They extend equipment life and reduce maintenance.

References

GB/T 7714: GUPTA R, SONG J. Powder metallurgy processing and mechanical properties of cemented tungsten carbide composites[J]. International Journal of Refractory Metals and Hard Materials, 2020, 91: 105246.

APA 7th: Gupta, R., & Song, J. (2020). Powder metallurgy processing and mechanical properties of cemented tungsten carbide composites.

MLA 9th: Gupta, R., and J. Song. "Powder Metallurgy Processing and Mechanical Properties of Cemented Tungsten Carbide Composites."